User's Manual

Getting Started 1 - 11
2. Ensure the convertible mount hook on the front of the cradle is inserted with the hook facing up. If not, remove
and reverse the hook so that it is in position to secure the digital scanner in place. (See Figure 1-3 on page 1-4
for the location of the convertible mount hook.)
3. Ensure the desk/wall mount converter knob is in the position shown in Figure 1-8.
Figure 1-8 Vertical Mount - Inserting the Digital Scanner in the Cradle
Radio Communications
The digital scanner can communicate with remote devices via Bluetooth Technology Profile Support, or by pairing
with a cradle. For radio communication parameters, detailed information about operational modes, Bluetooth
Technology Profile Support and pairing, see Chapter 4, Radio Communications.
Configuring the Digital Scanner
Use the bar codes in this manual or the 123Scan
2
configuration program to configure the digital scanner. See
Chapter 5, User Preferences & Miscellaneous Digital Scanner Options for information about programming the
digital scanner using bar code menus. Also see each host-specific chapter to set up connection to a specific host
type. See Chapter 12, 123Scan2 to configure the digital scanner using this configuration program.
Desk/Wall
Mount
Converter Knob
NOTE For your convenience, a wall mount bracket can be purchased from Motorola. For the appropriate
measurements and instructions on mounting the cradle, refer to the STB4278/STB4208 Quick Reference
Guide (p/n 72-71010-xx).