User's Manual

Keyboard Wedge Interface 8 - 3
If a power supply is used, disconnect the power supply before changing host cables or the cradle may not
recognize the new host.
Keyboard Wedge Parameter Defaults
Table 8-1 lists the defaults for Keyboard Wedge host parameters. To change any option, scan the appropriate bar
code(s) in the Keyboard Wedge Host Parameters section beginning on page 8-4.
NOTE Interface cables vary depending on configuration. The connectors illustrated in Figure 8-1 are examples
only. The connectors may be different than those illustrated, but the steps to connect the cradle remain the
same.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 8-1 Keyboard Wedge Host Default Table
Parameter Default
Page
Number
Keyboard Wedge Host Parameters
Keyboard Wedge Host Type
IBM PC/AT& IBM PC Compatibles
1
8-4
Country Types (Country Codes) North American 8-5
Ignore Unknown Characters Send 8-6
Keystroke Delay No Delay 8-7
Intra-Keystroke Delay Disable 8-7
Alternate Numeric Keypad Emulation Disable 8-8
Caps Lock On Disable 8-8
Caps Lock Override Disable 8-9
Convert Wedge Data No Convert 8-9
Function Key Mapping Disable 8-10
FN1 Substitution Disable 8-10
Send and Make Break Send 8-11
1
User selection is required to configure this interface and this is the most common selection.