Symbol CS3070 Quick Reference Guide
Symbol CS3070 © 2010 by Motorola, Inc. All rights reserved. No part of this publication may be reproduced or used in any form, or by any electrical or mechanical means, without permission in writing from Motorola. This includes electronic or mechanical means, such as photocopying, recording, or information storage and retrieval systems. The material in this manual is subject to change without notice. The software is provided strictly on an “as is” basis.
Quick Reference Guide 3 Introduction This document provides basic instructions for setting up, programming, and using the CS3000 series scanners. The scanner is available in the following configurations: • CS3000 - USB (batch), 0.5 GB Flash • CS3070 - USB (batch) and Bluetooth, 0.5 GB Flash Each scanner includes a USB host cable. A charging cradle is also available for mounting, charging, and host connection.
Symbol CS3070 3. Connect the other end of the host cable to a USB port on the host PC. Illustration to come Charging via Charging Cradle 1. Insert the cradle’s USB connector into a USB port on the host PC. 2. Remove the protective cover from the scanner. 3. Place the scanner in the cradle, ensuring the mini-USB connector in the cradle inserts into the interface port on the scanner.
Quick Reference Guide 5 Connecting to a Host Batch Connection See Charging on page 3 for instructions on connecting the scanner to a host PC via USB. Note To enter batch scanning mode, the scanner cannot be paired to a Bluetooth host (applies to CS3070 model only). Bluetooth Connection Pairing For RF-enabled scanners, to pair to a Bluetooth-enabled host: Note If the host does not support Bluetooth communication, a third-party Bluetooth adapter is required. 1.
Symbol CS3070 4. Select the CS3070 from the discovered device list. The Bluetooth application may prompt you to scan a passkey it generated, or for you to create and then scan a pin. 5. Scan Numeric Bar Codes on page 8 corresponding to the passkey, then scan Enter on page 9. The Bluetooth button blinks slowly to indicate that the scanner paired with the host. Note Bluetooth pairing suspends temporarily while charging via a USB cable. Disconnecting the cable re-establishes the Bluetooth pairing.
Quick Reference Guide 7 Bluetooth Communication Options To set up the scanner for communication with a host using standard Bluetooth profiles, scan one of the following bar codes. • Serial Port Profile (Slave) - The scanner connects to the host via Bluetooth and emulates a serial connection. The scanner accepts an incoming connection requested from a remote device and is the slave. Scan Serial Port Profile (Slave) and wait for the incoming connection.
Symbol CS3070 Numeric Bar Codes 0 1 2 3 4 5
Quick Reference Guide 6 7 8 9 Enter 9
Symbol CS3070 Scanning To scan bar codes: 1. Aim the scanner at the bar code. 2. Press the scan (+) button. Illustration to come 3. Ensure the scan line crosses every bar and space of the symbol. RIGHT 012345 WRONG 012345 The scanner beeps and the LED turns green to indicate a successful decode. See User Indications for beeper and LED definitions.
Quick Reference Guide 11 Deleting Bar Codes In batch mode, to delete a bar code aim the scanner at the bar code and press the function ( - ) button. Note Bar codes cannot be deleted in Bluetooth mode.
Function Symbol CS3070 User Action LED Beeper Clear All Hold (with Delete function (-) and Clear key All disabled) None None USB connection to host Connect scanner to host Flashing None amber charging; solid green charged Data protection toggle (when enabled) Hold both None -> Short long scan (+) solid amber short and function (-) keys for 6 seconds Bluetooth Press radio enable Bluetooth (ready to button pair with a host) Rapidly flashing blue LED None Bluetooth Press radio pairing Bluetoo
Quick Reference Guide 13 Transmitting Bar Code Data to Host Transferring Data from a Batch Scanner The BarcodeFile.txt file within the \Scanned Barcodes directory on the scanner stores scanned bar code data. Connect the scanner to the host PC via USB host cable or the charging cradle and use Windows Explorer to navigate to the scanner. Copy the bar code data file to the host. Note The scanner also supports an autorun feature where the customer can build an autorun.
Symbol CS3070 Regulatory Information This device is approved under the Symbol Technologies brand: Symbol Technologies, Inc., is the Enterprise Mobility business of Motorola, Inc. ("Motorola"). This guide applies to the following Model Numbers: CS3070, CS3000. Wireless information applies to CS3070 only. All Motorola/Symbol devices are designed to be compliant with rules and regulations in locations they are sold and will be labeled as required.
Quick Reference Guide 15 Health and Safety Recommendations Ergonomic Recommendations Caution: In order to avoid or minimize the potential risk of ergonomic injury follow the recommendations below. Consult with your local Health & Safety Manager to ensure that you are adhering to your company's safety programs to prevent employee injury.
Symbol CS3070 When driving a car, driving is your first responsibility - Give full attention to driving. Check the laws and regulations on the use of wireless devices in the areas where you drive. Always obey them. "The wireless industry reminds you to use your device / phone safely when driving". Warnings for Use of Wireless Devices Please observe all warning notices with regard to the usage of wireless devices.
Quick Reference Guide 17 Other Medical Devices Please consult your physician or the manufacturer of the medical device, to determine if the operation of your wireless product may interfere with the medical device. RF Exposure Guidelines Safety Information Reducing RF Exposure - Use Properly Only operate the device in accordance with the instructions supplied. International The device complies with internationally recognized standards covering human exposure to electromagnetic fields from radio devices.
Symbol CS3070 Laser Devices Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007. EN60825-1: 2007 IEC60825-1 (Ed. 2.0) The laser classification is marked on one of the labels on the device. Class 1 Laser devices are not considered to be hazardous when used for their intended purpose.
Quick Reference Guide 19 Batteries Battery Information Motorola/Symbol rechargeable battery packs are designed and constructed to the highest standards within the industry. However, there are limitations to how long a battery can operate or be stored before needing replacement. Many factors affect the actual life cycle of a battery pack, such as heat, cold, harsh environmental conditions and severe drops.
• • • • • • • • • • Symbol CS3070 Severe impact from dropping any battery-operated device on a hard surface could cause the battery to overheat. Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals. Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids, or expose to fire, explosion, or other hazard.
Quick Reference Guide • 21 Consult the dealer or an experienced radio/TV technician for help. Radio Transmitters (Part 15) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Symbol CS3070 Waste Electrical and Electronic Equipment (WEEE) English: For EU Customers: All products at the end of their life must be returned to Motorola for recycling. For information on how to return product, please go to: http://www.motorola.com/recycling/weee. Bulgarish: За клиенти от ЕС: След края на полезния им живот всички продукти трябва да се връщат на Motorola за рециклиране. За информация относно връщането на продукти, моля отидете на адрес: http://www.motorola.com/recycling/weee.
Quick Reference Guide 23 Lietuvių: ES vartotojams: visi gaminiai, pasibaigus jų eksploatacijos laikui, turi būti grąžinti utilizuoti į kompaniją „Motorola“. Daugiau informacijos, kaip grąžinti gaminį, rasite: http://www.motorola.com/recycling/weee. Magyar: Az EU-ban vásárlóknak: Minden tönkrement terméket a Motorola vállalathoz kell eljuttatni újrahasznosítás céljából. A termék visszajuttatásának módjával kapcsolatos tudnivalókért látogasson el a http://www.motorola.com/recycling/weee weboldalra.
Service Information If you have a problem using the equipment, contact your facility’s Technical or Systems Support. If there is a problem with the equipment, they will contact the Motorola Enterprise Mobility Support at: http://www.motorola.com/enterprisemobility/ contactsupport For the latest version of this guide go to: http://www.motorola.com/enterprisemobility/ manuals Motorola, Inc. One Motorola Plaza Holtsville, New York 11742, USA 1-800-927-9626 http://www.motorola.
