User's Manual

Quick Reference Guide 7
Pairing
Pairing registers a digital scanner to the cradle such that the digital
scanner and cradle can exchange information. The cradle operates in two
modes: Point-to-Point and Multipoint-to-Point. In Point-to-Point mode, pair
the digital scanner to the cradle either by inserting it in the cradle (if pair on
contacts is enabled), or by scanning the pairing bar code. In
Multipoint-to-Point mode, you can pair up to seven digital scanners to one
cradle.
To pair the digital scanner with the cradle, scan a pairing bar code. A
high-low-high-low beep sequence followed by a low-high beep sequence
indicates successful pairing and connection to the remote device. A long
low, long high beep sequence indicates unsuccessful pairing.
Lost Connection to Host
If scanned data does not transmit to the cradle’s host, ensure that all
cables are firmly inserted and the power supply is connected to an
appropriate AC outlet, if applicable.
If scanned data still does not transmit
to the host, reestablish a connection with the host:
1. Disconnect the host interface cable from the cradle.
2. Wait three seconds.
3. Reconnect the host interface cable to the cradle.
4. Reestablish pairing with the cradle by scanning the pairing bar code.
Charging the Digital Scanner Battery in the
Cradle
When using a new battery in the digital scanner, the battery requires a
charge to be enabled. Insert the battery in the digital scanner and place
the digital scanner in the cradle (see
Inserting the Digital Scanner in the
Cradle. on page 6). The battery begins charging when the cradle LED
indicator starts flashing amber. The battery is fully charged when the
cradle LED is solid green. A complete charge of a fully discharged battery
can take up to three hours using external power.
NOTE The pairing bar code that connects the digital scanner to a
cradle is unique to each cradle.
Do not scan data or parameters until pairing completes.
Draft 1