User's Manual

Quick Reference Guide 5
Using a DC Power Supply
The cradle can operate from host supplied power, if available. If host
power is limited or not available, an external DC power supply can be
used with certain host interface cables that support a power jack. An
external power supply is recommended if fastest charging is required.
Mounting the Cradle
Horizontal Mount
When placing the cradle on a tabletop, the rubber feet on the bottom of
the cradle provide traction and prevent surface damage.
75 Degree Mount
The cradle can be mounted at a 75
° angle (maximum) using the two brass
threaded screw holes.
1. Position the cradle on the mounting surface and mark the surface on
either side of the cradle.
2. Pre-drill two holes to accommodate the two brass threaded screw
holes. Drill the holes 45.5 mm (1.8 in) apart.
1. Attach the interface and power cables
(see
Cradle Connections on page 4).
CAUTION Always disconnect the DC power supply BEFORE
disconnecting the cable to the host end or the cradle
may not recognize the new host.
NOTE When mounting the cradle on a mobile cart it is
recommended to mount the cradle securely on the surface.
NOTE The 75
° mount is used in Lamp Mode for Healthcare units
only. Refer to the Product Reference Guide for information
on Lamp Mode.
45.5 mm
(1.8 in)
Note: Drawing is not to scale.
Draft 1