User's Manual
Table Of Contents
- Introduction
- Equipment Supplied
- Accessories
- Related Documentation
- Service Information
- Cradle Features
- Cradle Connections
- Inserting the Digital Scanner in the Cradle.
- Sending Data to the Host Computer
- Charging the Digital Scanner Battery in the Cradle
- Troubleshooting
- Health and Safety Recommendations
- Regulatory Information
- Bluetooth® Wireless Technology
- Power Supply
- Wireless Device Country Approvals
- Warnings for Use of Wireless Devices
- RF Exposure Guidelines
- Radio Frequency Interference Requirements-FCC
- CE Marking and European Economic Area (EEA)
- Statement of Compliance
- Japan (VCCI) - Voluntary Control Council for Interference
- Korea Warning Statement for Class B ITE
- Brazil (UNWANTED EMISSIONS - ALL PRODUCTS)
- Chile
- China
- Eurasian Customs Union
- Mexico
- South Korea
- Taiwan
- Waste Electrical and Electronic Equipment (WEEE)
- CMM Disclosure
4 CR8178-PC Presentation Cradle
Bottom
Cradle Connections
1. Connect the appropriate cable to the power supply and an AC power
source, if necessary. This ensures detection of the host and prevent
inadvertently back powering the cradle from improper detection of the
host.
2. Insert the interface cable into the host port.
3. Insert the interface cable into the cradle’s host port.
4. Pair the digital scanner to the cradle either by inserting it in the cradle
(if Pair on Contacts is enabled) or by scanning the pairing bar code.
5. If necessary, scan the appropriate host bar code (for non-autodetected
interfaces). Refer to the Product Reference Guide.
Changing the Host Interface
To connect to a different host, or to the same host through a different
cable:
1. Unplug the interface cable from the host.
2. Unplug the power supply from the cradle.
3. Connect the interface cable to the new host, or the new interface cable
to the existing host.
4. Reconnect the power supply, if required.
5. If necessary, scan the appropriate host bar code (for non-autodetected
interfaces). Refer to the Product Reference Guide.
Rubber Feet
Rubber Feet
Interface Port
Station Mount
Threaded Brass
Screw Holes
(2 - M4 x 5 mm)
Draft 1