User's Manual

6 CR2278 Presentation Cradle
Lost Connection to Host
If scanned data does not transmit to the cradle’s host, ensure that all
cables are firmly inserted and the power supply is connected to an
appropriate AC outlet, if applicable.
If scanned data still does not transmit
to the host, reestablish a connection with the host:
1. Disconnect the host interface cable from the cradle.
2. Wait three seconds.
3. Reconnect the host interface cable to the cradle.
4. Reestablish pairing with the cradle by scanning the pairing bar code.
Charging the Digital Scanner Battery in the
Cradle
When using a new battery in the digital scanner, the battery requires a
charge to be enabled. Insert the battery in the digital scanner and place
the digital scanner in the cradle (see
Inserting the Digital Scanner in the
Cradle. on page 5). The battery begins charging when the cradle LED
indicator starts flashing amber. The battery is fully charged when the
cradle LED is solid green. A complete charge of a fully discharged battery
can take up to three hours using external power.
Cradle LED Indicators
???verify/update
LED Indication
Standard Use
Green (stays on) Power Up
Radio Indications
Green (off, then on) Bluetooth connection established
Battery Indications
Amber (stays on) Pre-charging
Amber blinking Charging
Green (stays on) Fully charged
Amber fast blinking Charging Error
Battery End of Life Indications
Red blinking Charging
Red (stays on) Fully charged
Red fast blinking Charging error
Draft 1