User's Manual
Table Of Contents
- 1. Regulatory Information
- 2. Wireless Device Country Approvals
- 3. Radio Frequency Interference Requirements- FCC
- 4. Radio Frequency Interference Requirements- Canada
- 5. CE Marking and European Economic Area (EEA)
- 6. Waste Electrical and Electronic Equipment (WEEE)
Regulatory Guide (RG) Rev. A
Zebra Technologies Corporation Page 6 of 9
Zebra Confidential Restricted
The antenna list and types are included in the following table:
Part Number
Antenna
Type
2.4
GHZ
Gain
(dBi)
Impedance
(Ohms)
ML-2452-HPAG4A6-01 Dipole 4 50
ML-2452-APAG2A1-01 Dipole 2.7 50
ML-2452-HPA6-01 Dipole 5.3 50
ML-2452-APA2-01 Dipole 3.17 50
ML-2452-PNA5-01R Panel 5.5 50
ML-2452-SEC5M4-N36 Polarized
Panel
6.92 50
ML-2452-PTA4M4-036 Patch 5 50
ML-2499-HPA6H-01 Polarized
Dipole
5.4 50
ML-2452-HPAG4A6-01 Polarized
Dipole
4 50
CEDAR-INT-ANT Mono
pole
5.2 N/A
Le présent émetteur radio (CDR2G) a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne
énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les
types d'antenne non inclus dans cette liste ou dont le gain est supérieur au gain maximal indiqué, sont strictement
interdits pour l'exploitation de l'émetteur.
This module is intended for OEM integrator. The OEM integrator is still responsible for the IC compliance requirement
of the end product, which integrates this module.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep at least 40 cm separation with the
antenna while this end product is installed and operated. The end user has to be informed that the IC radio-frequency
exposure guidelines for an uncontrolled environment can be satisfied. The end user has to also be informed that any
changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this
equipment. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains IC: 109AN-CDR2G ".
The Host Model Number (HMN) must be indicated at any location on the exterior of the end product or product
packaging or product literature which shall be available with the end product or online.