User's Manual

Appendix A Customer Support A - 3
A.2 Beacon Part Number: MPACT-T1B20-000-WR (Model # ATLS-T1B)
As a prerequisite, the following hardware items are required to mount the tie-wrap style beacon housing to a pole or
similar structure:
• Beacon (tie-wrap style housing), part number - MPACT-T1B20-000-WR
• Plastic tie wraps for attaching each beacon housing to the shelf
Installing the Tie-Wrap Style Beacon
Tie-wrap beacon housings are designed to attach to vertical or horizontal poles or similar mounting surfaces.In the image
below, there are openings located on the back of the beacon housing allowing a tie wrap to be inserted through the
openings and wrapped around a pole or similar structure.
Notice there is an up arrow located on the middle of the beacon housing. This up arrow shows the orientation for the
be
acon to rest in order for the beacon to function properly. In addition to the beacon’s up arrow orientation, the smooth
front of the beacon should face out, so that the beacon’s directional pattern faces out toward the aisle where the retail
customer is located, not facing over the shelves.
Figure A-1 Tie Wrap Style Beacon - Part Number - MPACT-T1B20-000-WR
To mount the tie wrap style beacon to a pole or similar structure:
1. Using a site floor plan, determine the exact Place Holder
location on the site floor plan for the beacon.
Physically mounting the beacon should be done in conjunction
with the software process of associating the beacon
with the place holder in the MPact Toolbox application. After the technician associates the beacon with the place
holder, the beacon is physically affixed to a poll or similar structure on the site floor.
2. Mount the beacon to a pole or similar
structure using the plastic tie wrap.
When mounting the beacon, make sure the bar code label is face up toward the ceiling and the front of the beacon is
facing
outward toward the aisle where the retail customer is expected to dwell.
DRAFT 2B - 12 June 2014