User's Manual

Beacon Installation and Activation 4 - 5
6. When the installation popup displays, select Scan Barcode.
Figure 4-6 MPact Toolbox - Scan Barcode
7. Select Done, then select Save.
Within twenty seconds, the beacon connects to the toolbox. A successful installation results in the beacon being located
in the intended place holder position and in an inactive state; the interior of the beacon is grey.
Figure 4-7 MPact Toolbox - Successful Beacon Installation
NOTE: If the beacons have been pre-configured on the server with a specific ID, be sure
to select the proper beacon with the correct ID that matches what is shown on the
beacon installation popup display.
DRAFT 2B - 12 June 2014