User's Manual

Table Of Contents
20 AP-8533 Access Point
Phillips head screw driver, or drill and drill bit
2.5.1 Wall Mount Procedure - New Installation
This section describes a new AP-8533 installation with no previous Access
Point existing on the intended wall surface.
1. Place the mounting bracket against the wall.
2. Mark the screw hole locations depending on the intended deployment
orientation of the unit.
3. At each point, drill a hole in the wall and attach the mounting bracket.
4. Place the Access Point on the mounting bracket.
Note • When pre-drilling a hole the recommended hole size is 4mm (0.16in.).