User's Manual

Installation Guide 15
2 Hardware Installation
2.1 Installation Instructions
An AP-8533 Access Point mounts either on a wall (with M 3.5 x 0.6 x 23 MM
pan head screws and mounting bracket or equivalent) or on a suspended
ceiling T-bar.
To prepare for the installation:
1. Match the part number on the purchase order with the part numbers in
the packing list and on the case of the Access Point.
2. Verify the contents of the box include the intended AP-8533 Access
Point, and the included hardware matches the package contents (see
AP-8533 Package Contents on page 8).
3. Review site survey and network analysis reports to determine the
location and mounting position for the AP-8533 Access Point.
4. Connect a CAT-5 or better Ethernet cable to a compatible 802.3at or
802.3af power source and run the cable to the installation site. Ensure
there is sufficient slack on the cable to perform the installation steps.
Part Number Description
AP-8533-68SB30-US
AP-8533 tri radio 802.11ac 4x4:4 MIMO Access Point
external antenna 2xGE US version
AP-8533-68SB30-WR
AP-8533 tri radio 802.11ac 4x4:4 MIMO Access Point
external antenna 2xGE International version
AP-8533-68SB30-EU
AP-8533 tri radio 802.11ac 4x4:4 MIMO Access Point
external antenna 2xGE EU version
AP-8533-68SB40-US
AP-8533 tri radio 802.11ac 4x4:4 MIMO Access Point
external antenna 2xGE US version
AP-8533-68SB40-EU
AP-8533 tri radio 802.11ac 4x4:4 MIMO Access Point
external antenna 2xGE EU version
AP-8533-68SB40-WR
AP-8533 tri radio 802.11ac 4x4:4 MIMO Access Point
external antenna 2xGE International version
Note • When operating in a Gigabit Ethernet environment, CAT-5e or CAT-6
cable is recommended for Gigabit operation.