User's Manual

14 AP-8432 Access Point
For Power Injector installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the
Power Injector Data & Power Out connector and the Access Point’s
GE1/POE port.
b. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the
network data supply (host) and the Power Injector Data In
connector.
c. Ensure the cable length from the Ethernet source (host) to the
Power Injector and Access Point does not exceed 100 meters
(333 ft). The Power Injector has no On/Off power switch. The Power
Injector receives power as soon as AC power is applied.
For standard power adapter (non Power Injector) and line cord
installations:
a. Connect a RJ-45 Ethernet cable between the network data supply
(host) and the Access Point’s GE1/POE port.
b. Verify the power adapter is correctly rated according to the country
of operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the
Access Point.
e. Attach the power supply line cord to a power supply.
6. Verify the Access Point is receiving power by observing the LEDs are lit
or flashing. For more information on AP-8432 LED behavior, see LED
Indicators on page 18.
The Access Point is ready to configure.
Caution • If not using an AP-PSBIAS-2P3-ATR Power Injector, ensure
only the AP-8432’s designated power supply (PWR-BGA48V45W0WW) is
used to supply power to the Access Point. Using an incorrectly rated
power supply could damage the Access Point and void the product
warranty. Do not actually connect to the power source until the cabling
portion of the installation is complete.
AP8432_IG.book Page 14 Monday, March 14, 2016 8:39 AM