User's Manual

Installation Guide 13
2.5.1 Wall Mount Procedure - New Installation
This section describes a new AP-8432 installation with no previous Access
Point existing on the intended wall surface.
1. Place the mounting bracket against the wall.
2. Mark the screw hole locations depending on the intended deployment
orientation of the unit.
3. At each point, drill a hole in the wall and attach the mounting bracket.
4. Place the Access Point on the mounting bracket.
5. Cable the Access Point using either the Power Injector solution
(AP-PSBIAS-2P3-ATR) or the approved AP-8432 power supply
(PWR-BGA48V45W0WW).
Note • When pre-drilling a hole the recommended hole size is 4mm (0.16in.).
AP8432_IG.book Page 13 Monday, March 14, 2016 8:39 AM