User's Manual

Installation Guide 9
reducing the burden of installation and allowing optimal Access Point placement in respect to
the intended coverage area.
The
AP-PSBIAS-2P3-ATR Power Injector is a high power POE Injector delivering up to 30 watts.
The Access Point can only use a Power Injector when connecting the unit to the Access Point’s
GE1/POE port. The Power Injector is separately ordered and not shipped with an existing
AP SKU.
The Access Point’s Power Supply is not included with the Access Point and is orderable
separately as an accessory. Disconnecting the AC power from the PWRS-14000-148R causes
the Access Point to re-boot before sourcing power from the POE power injector. If the AP is
operating using injector supplied power, the AP will not automatically reboot if an AC adapter
is connected. The Access Point continues to operate with power supplied from the AC adapter
without change to the Access Point operating configuration. If using AC adapter supplied
power and a change to the AP’s operating configuration is warranted, the Access Point needs
to be manually rebooted by the customer.
CAUTION Using a non-compliant injector, or an injector supporting
legacy modes will not allow the AP-7622 to function at
optimum performance levels.
CAUTION Do not plug the AP-PSBIAS-2P3-ATR Power Injector into
the Access Point’s Console port. Connecting the Power
Injector into the console port can damage the port and
void the AP-7622’s product warranty.
CAUTION The Access Point supports any standards-based
compliant power source. However, using the wrong
solution (including a POE system used on a legacy
Access Point) could either limit functionality or severely
damage the Access Point and void the product warranty.
!
!
!