User's Manual

26 AP-7622 Access Point
5.5 Power Supply
Use ONLY a Zebra approved UL LISTED ITE (IEC/EN 60950-1, LPS/SELV) power supply with
electrical ratings: Output 12Vdc, min 1A, with a maximum ambient temperature of at least 40
degrees C. Use of alternative power supply will invalidate any approvals given to this unit and
may be dangerous.
Alternately this device may be powered from a 802.3af compliant power source which has
been certified by the appropriate agencies, or by a Zebra approved UL LISTED ITE (IEC/EN
60950-1, LPS/SELV) power supply with electrical ratings: Output 48Vdc, min 0.25A, with a
recommended ambient temperature greater than 50 degrees C. Use of alternative power
supply will invalidate any approvals given to this unit and may be dangerous.
5.6 Radio Frequency Interference Requirements—FCC
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
5.6.1 Radio Transmitters (Part 15)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.