User's Manual

Installation Guide 17
3 Basic Access Point Configuration
Once the Access Point is installed and powered on, complete the following WiNG Assist
configuration steps to get the Access Point up and running with minimal administrative
intervention.
Startup Assist updates existing settings. To delete or revise existing Startup Assist settings,
either rerun Startup Assist or navigate to where those parameters appear in the user interface
and update them accordingly. Refer to the Access Point’s more advanced configuration
documentation available on the Zebra support site for updating the management interface
beyond the scope of the WiNG Assist configuration described in this guide. For more
information, see www.zebra.com/support
.
1. Power the Access Point using an appropriate power adapter, PoE injector, or PoE
switch.
2. Connect to the Access Point.
The default IP address is located on the backside of the Access Point.
3. Enter the default username admin in the Username field.
4. Enter the default password admin123 in the Password field.
5. Select the Login button to load the management interface.
If logging in using a factory default configuration, Startup Assist automatically
displays.