User's Manual

12 AP-7622 Access Point
2. Drill pilot holes at the locations marked on the wall.
3. Cable the Access Point using the Power Injector solution, approved AP-7622 power
supply or a POE enabled switch.
For Power Injector installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the Power Injector
Data & Power Out connector and the Access Point’s GE1/POE port.
b. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data
supply (host) and the Power Injector Data In connector.
c. Ensure the cable length from the Ethernet source (host) to the Power Injector and
Access Point does not exceed 100 meters (333 ft). The Power Injector has no
On/Off switch. The Power Injector receives power as soon as AC power is applied.
For standard power adapter (non Power Injector) and line cord installations:
a. Connect a RJ-45 Ethernet cable between the network data supply (host) and the
Access Point’s GE1/POE port.
b. Connect the power supply line cords to the power adapter.
c. Attach the power adapter cable into the power connector on the Access Point.
d. Attach the power supply line cord to a power supply or POE enabled switch.
4. Verify the Access Point is receiving power by observing the LEDs are lit or flashing. For
more information on AP-7622 LED behavior, see LED Indicators on page 15.
5. Secure the AP-7622 to the wall using oval head screws.
6. The Access Point is ready to configure.
NOTE Zebra recommends wrapping the auxiliary power adapter
cable around the Access Point’s cable hook to avoid
accidental disconnection.