User's Manual

10 AP-7622 Access Point
A separate Power Injector is required for each AP-7622 Access Point comprising the network.
The Power Injector can be installed free standing, on an even horizontal surface or wall
mounted using the power injector’s wall mounting key holes. The following guidelines should
be adhered to before cabling the Power Injector to an Ethernet source and an Access Point:
• Do not block or cover airflow to the Power Injector.
• Keep the Power Injector away from excessive heat, humidity, vibration and dust.
• The Power Injector isn’t a repeater, and does not amplify the Ethernet signal. For
optimal performance, ensure the Power Injector is placed as close as possible to the
data port.
CAUTION To avoid problematic performance and restarts, disable
POE from a wired switch port connected to an Access
Point if mid-span power sourcing equipment (PSE) is
used between the two, regardless of the manufacturer of
the switch.
!