User's Manual
Table Of Contents
- 1 Introduction
- 2 Hardware Installation
- 3 Basic Access Point Configuration
- 4 AP-7522 Access Point Specifications
- 5 Regulatory Information
- 5.1 Regulatory Information
- 5.2 Wireless Device Country Approvals
- 5.3 Health and Safety Recommendations
- 5.4 RF Exposure Guidelines
- 5.5 Power Supply
- 5.6 Radio Frequency Interference Requirements—FCC
- 5.7 CE Marking and European Economic Area (EEA)
- 5.8 Statement of Compliance
- 5.9 Japan (VCCI) - Voluntary Control Council for Interference
- 5.10 Korea Warning Statement for Class B ITE
- 5.11 Other Countries
- 5.12 Waste Electrical and Electronic Equipment (WEEE)
- 5.13 TURKISH WEEE Statement of Compliance
- 6 Support
- 7 Symbol Technologies End-User Software License Agreement
- 8 AP-7522 Access Point China ROHS Compliance
Installation Guide 19
The LEDs provide a status display indicating error conditions, transmission, and network activity for the 5 GHz
802.11ac (amber) radio and the 2.4 GHz 802.11n (green) radio.
Task 5 GHz Activity LED (Amber) 2.4 GHz Activity LED (Green)
Unconfigured
Radio
On On
Normal
Operation
• If this radio band is enabled:
Blink at 5 second interval
• If this radio band is disabled:
Off
• If there is activity on this band:
Blink interval at 1 time per second
• If this radio band is enabled:
Blink at 5 second interval
• If this radio band is disabled:
Off
• If there is activity on this band:
Blink interval at 1 time per second
Firmware
Update
On Off
Locate AP
Mode
LEDs blink in an alternating green, red and
amber pattern using an irregular blink rate.
This LED state in no way resembles normal
operating conditions.
LEDs blink in an alternating green, red and
amber pattern using an irregular blink rate.
This LED state in no way resembles normal
operating conditions