User's Manual
Table Of Contents
- 1 Introduction
- 2 Hardware Installation
- 3 Basic Access Point Configuration
- 4 Specifications
- 5 Regulatory Information
- 5.1 Regulatory Overview
- 5.2 Wireless Device Country Approvals
- 5.3 Health and Safety Recommendations
- 5.4 RF Exposure Guidelines
- 5.5 Power Supply
- 5.6 Wireless Devices - Countries
- 5.7 Radio Frequency Interference Requirements—FCC
- 5.8 Radio Frequency Interference Requirements – Canada
- 5.9 CE Marking and European Economic Area (EEA)
- 5.10 Waste Electrical and Electronic Equipment (WEEE)
- 5.11 TURKISH WEEE Statement of Compliance
- 6 Motorola Solutions Support Center
- 7 AP7131 Series ROHS Compliance
28 AP-7131 Access Point
The Initial Setup Wizard displays a Navigation Panel on the left-hand side of each screen to assist the
administrator in assessing which tasks still require completion before the Access Point can be deployed
into service.
A green checkmark to the left of an item in the Navigation Panel defines the task as having its minimum
required configuration set correctly. A red X defines a task as still requiring at least one parameter be
defined correctly.
The tasks populating the Navigation Panel differ depending on whether a Typical Setup (Recommended)
or Advanced Setup is selected as the setup option. Select Save/Commit within each page to save the
updates made to that page's configuration. Select Next to proceed to the next page listed in the
Navigation Panel. Select Back to revert to the previous screen in the Navigation Panel without saving your
updates. The Introduction screen displays a list of the basic configuration activities supported by the Initial
Setup Wizard.
NOTE While you can navigate to any page in the navigation panel, you cannot
complete the Initial AP Setup Wizard until each task in the Navigation
Panel has a green checkmark.