User's Manual
Table Of Contents
- 1 Introduction
- 2 Hardware Installation
- 3 Basic Access Point Configuration
- 4 Specifications
- 5 Regulatory Information
- 5.1 Regulatory Overview
- 5.2 Wireless Device Country Approvals
- 5.3 Health and Safety Recommendations
- 5.4 RF Exposure Guidelines
- 5.5 Power Supply
- 5.6 Wireless Devices - Countries
- 5.7 Radio Frequency Interference Requirements—FCC
- 5.8 Radio Frequency Interference Requirements – Canada
- 5.9 CE Marking and European Economic Area (EEA)
- 5.10 Waste Electrical and Electronic Equipment (WEEE)
- 5.11 TURKISH WEEE Statement of Compliance
- 6 Motorola Solutions Support Center
- 7 AP7131 Series ROHS Compliance
Installation Guide 23
2.5.1 Three Radio AP7131 LEDs
A three radio model AP7131N Access Point has the following unique LED behavior:
2.5.2 Dual Radio (2.4/5 GHz) LEDs
A dual radio model Access Point has the following unique LED behavior:
LED 1 LED 2 (LAN) LED 3 (WAN) LED 4 - 5 GHz LED 5 - 2.4 GHz LED 6
Blinking Red
indicates booting.
Solid Red defines
the diagnostic
mode.
White defines
normal operation.
Blinking Green
indicates normal
GE1 operation.
Blinking Yellow
indicates port error.
Blinking Green
indicates normal
GE2 operation.
Blinking Yellow
indicates port error.
Amber is on when
the radio is
configured for
802.11a/n. Blinking
Amber indicates
radio activity. When
functioning as a
sensor, LED
alternates between
Amber and Yellow.
The blink interval is
1 second. When no
Server is connected,
the Yellow LED is
always on.
Emerald is on when
the radio is
configured for
802.11bgn. Blinking
Emerald indicates
radio activity. When
functioning as a
sensor, LED
alternates between
Emerald and
Yellow. The blink
interval is 1 second.
When no Server is
connected, the
Yellow LED is
always on.
Amber indicates
that the radio is
defined as a sensor,
but is not
connected to server.
Alternates between
Emerald and
Amber when the
radio is defined as a
sensor and a server
is connected. The
blink interval is 1
second.
LED 1 LED 2 (LAN) LED 3 (WAN) LED 4 - 5 GHz LED 5 - 2.4 GHz LED 6
Blinking Red
indicates booting.
Solid Red defines
the diagnostic
mode.
White defines
normal operation.
Blinking Green
indicates normal
GE1 operation.
Blinking Yellow
indicates port error.
Blinking Green
indicates normal
GE2 operation.
Blinking Yellow
indicates port error.
Amber is on when
the radio is
configured for
802.11a/n. Blinking
Amber indicates
radio activity. When
functioning as a
sensor, LED
alternates between
Amber and
Yellow. The blink
interval is 1 second.
When no Server is
connected, the
Yellow LED is
always on.
Emerald is on
when the radio is
configured for
802.11bgn. Blinking
Emerald indicates
radio activity. When
functioning as a
sensor, LED
alternates between
Emerald and
Yellow. The blink
interval is 1 second.
When no Server is
connected, the
Yellow LED is
always on.
Not Used