User's Manual

AP-7131 Access Point: Installation Guide
24
As the AP-7131 is re-booting, a “Press esc key to run boot firmware” message displays.
5. Quickly press <ESC>.
If the <ESC> key is pressed within three seconds a boot> prompt displays.
6. Reset the AP-7131 by typing the following at the boot prompt: reset system
When the AP-7131 re-boots again, the password will return to its default value of
“motorola.” You can now access the AP-7131.
3.2 Configuring “Basic” Device Settings
Configure a set of minimum required device settings within the AP-7131 Quick Setup screen. The
values defined within the Quick Setup screen are also configurable in numerous other locations
within the AP-7131 menu tree. When you change the settings in the Quick Setup screen, the values
also change within the screen where these parameters also exist. Additionally, if the values are
updated in these other screens, the values initially set within the Quick Setup screen will be updated.
The following table illustrates the AP-7131’s default configuration.
To define a basic AP-7131 configuration:
CAUTION If the <ESC> key is not pressed within three seconds after the “Press
esc key to run boot firmware” message displays, the AP-7131 will
continue to boot.
WAN LAN 1 LAN 2
Access via WAN
port
Static IP: 10.1.1.1
Static Mask:
255.0.0.0
DHCP Client
Auto-Update
Enabled
Default Gateway
Ethernet Port
Enabled
Disabled HTTP, HTTPS, SSH,
SNMP, Telnet:
Enabled
!