User's Manual

Chapter 2: MWR Device Installation
6881011Y53-O September 2005
2-2
For a MOTOMESH deployment, a permanent power source for each MWR must be provided. All
infrastructure devices require professional installation to ensure that the installation is performed in
accordance with FCC licensing regulations
Infrastructure devices are fitted with two mounting brackets designed to be attached to light poles and
other probable installation sites. Alternate mounting hardware is available for mounting directly to
posts or structures that are too large for the standard brackets. Optional remote antenna mount
hardware is also available for use with the alternate mounting hardware.
Equipment Specification
The specifications listed in the following table apply for all Infrastructure devices.
Table 2-2 MOTOMESH Infrastructure Device Radio Characteristics
Characteristic
2.4GHz
802.11 b/g
2.4GHz
MEA
4.9GHz
802.11
4.9GHz
MEA
Output Power 23 dBm 24 dBm 23 dBm 24 dBm
RF Modulation CCK/OFDM QDMA OFDM QDMA
Operating Frequency (GHz) 2.412-2.462 2.40-2.48 4.945-4.985 4.950-4.965
Maximum Burst Data Rate 54 Mbps 6 Mbps 18 Mbps 6 Mbps
Spectrum Used 20 MHz 60 MHz 10 MHz 20 MHz
The following list defines the standard hardware components for IAPs and MWRs.
• Device Enclosure with 4 N-type Female Antenna Connector
• 120V A/C Power Cable with a NEMA 5-15 plug
• 4 Antennas with N-type Male Antenna Connector
• Weatherproof RJ-45 Connectors
• Mounting Bracket (Standard and Optional)
The Network Operator must supply the following equipment.
• Mounting Location
• Power Source (120V/240V A/C 50/60 Hz)
• Ethernet connection between the IAP and the MiSC
• (2) 7/16 inch wrenches