Installation Guide

5. Slide the Main antenna into the grooves on the left side of the unit until it is anchored in place. Insert the black
antenna to the socket labelled Black. Route it through the clips to secure it in place. Next, connect the grey GPS
jumper cable as shown.
6. Snap the WAN module onto the hand-held board, making sure to align the module pins with those on the board.
Insert 3 screws torqued to 2.5 in. lbs. Next, insert the yellow Diversity antenna into the socket labelled Yellow.
Connect the grey GPS cable, tucking it under the corner of board as shown. Insert the blue Main antenna into the
socket labelled Blue. Tuck the blue Main antenna under the WAN module shield. The cable should follow the silk
screen routing.
7. Add the fourth screw to secure the WAN module in place.
8. Replace the metal frame, sliding it in from the top. Take care not to damage the cables that have been connected.
Insert the four screws to a torque of 2.5 in. lbs.
9. Install the back cover (x6 screws) and the end-cap (x4 screws). Each is torqued to 2.5 in. lbs.
Main antenna
GPS jumper
cable
WAN module
Yellow diversity
antenna
Blue main
Grey GPS antenna
antenna
Fourth screw
COMPANY HEADQUARTERS SUPPORT SERVICES
Motorola Solutions, Inc. Contact the Motorola Solutions Global Customer Support at:
1301 E. Algonquin Rd. http://www.motorolasolutions.com/support.
Schaumburg, IL 60196-1078, U.S.A.
http://www.motorolasolutions.com