Installation Guide

Warning: Installation of any components must be performed using appropriate anti-static devices. If unavailable, dis-

charge body static by touching a grounded metallic object before opening any covers on the hand-held.

Note: If the unit does not have an imager or scanner end-cap attached, the WA6212 long blank end-cap is required.

The WA6212 end-cap is not included in the RA3051 kit. It must be ordered separately.

The RA3051 radio kit includes the UMTS PHS8-P Expansion Module along with the following:

• M2x4 Torx T6 screws (x4)

• GPS jumper cable

• WAN main antenna

• WAN diversity antenna

1. Remove the end-cap (x4 screws) and back cover (x6 screws).

2. Remove the metal frame (x4 screws), and remove the existing Wi-Fi antenna.

3. Slide the Diversity Antenna into the grooves along the right side of the unit.

4. Route the cables as indicated on the board – insert the red Wi-Fi antenna into the socket labelled Red and the

green GPS antenna into the socket labelled Green. Secure the cables by routing them through the clips.

Wi-Fi antenna

Metal

frame

Wi-Fi Diversity antenna

Wi-Fi Main antenna (red)

GPS antenna (green)

Route cables through clips

MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark

Holdings, LLC and are used under license. All other trademarks are the property of their respective owners.

February 18, 2014

8000323A

RA3051 WWAN RADIO KIT WITH ANTENNAS (WAN/GPS/WI-FI DIVERSITY)

INSTALLATION SHEET

PAGE 1
RA3051 WWAN RADIO KIT WITH ANTENNAS (WAN/GPS/WI-FI DIVERSITY) INSTALLATION SHEET Warning: Installation of any components must be performed using appropriate anti-static devices. If unavailable, discharge body static by touching a grounded metallic object before opening any covers on the hand-held. Note: If the unit does not have an imager or scanner end-cap attached, the WA6212 long blank end-cap is required. The WA6212 end-cap is not included in the RA3051 kit. It must be ordered separately.
PAGE 2
5. Slide the Main antenna into the grooves on the left side of the unit until it is anchored in place. Insert the black antenna to the socket labelled Black. Route it through the clips to secure it in place. Next, connect the grey GPS jumper cable as shown. GPS jumper cable Main antenna 6. Snap the WAN module onto the hand-held board, making sure to align the module pins with those on the board. Insert 3 screws torqued to 2.5 in. lbs.