User's Manual

Troubleshooting
Laminate Problems
980541-003 Rev. B Zebra P630i & P640i Card Printer User’s Manual 99
Laminate Problems
Laminate not centered on card
• Vertical offset adjust (mechanical adjustment).
• Horizontal offset: Properties > Device Settings > Printer Adjustment > Laminate
Station Adjust; see “Laminator Station Adjustments” on page 72.
Laminate not parallel with card edges
• Skew adjust (mechanical adjustment).
• If using partial width laminate, edge guide not properly installed (one of
two positions).
• Transfer guide not properly installed.
• Laminate patch wrapped around heated roller.
Laminate wrinkling
• Can occur at end of roll. Remove cassette. If nearly out, discard. Install fresh roll.
• If not end-of-roll problem, suspect obstructions in laminate feed path.
Laminate bunches up outside the cutter assembly
This can happen to either upper or lower laminates.
• Failing to latch the cassette. Unlatch the cassette, gently wiggle the cassette out of its
pocket, then latch the cassette.
• Out-of-square scissor cut on the leading edge of the laminate. You can make this
easier by cutting the laminate above the latch. Remove all laminate scraps.
• Leading edge of laminate not reeled in even with the lips of the cassette. Cut the
leading edge of the fresh laminate as square as you can with scissors, then reel it in,
re-install, and latch the cassette.
Note • Any time you unlatch a cassette, you must check that the laminate is even with the lips
of the cassette before re-latching.