User's Manual

Settings and Adjustments
Adjustments
980541-003 Rev. B Zebra P630i & P640i Card Printer User’s Manual 73
The standard laminate patch length is 3.25” (82.55mm). Accurate positioning of the laminate
is important for practical and aesthetic reasons. The laminate must cover the entire image as
printed at the time of issuance, thus protecting critical data with a tamper-deterrent film.
Additionally, because even the smallest amount of overhang can compromise the card’s
integrity, the patch should be symmetrically positioned on the card.
If there is no magnetic stripe on the underside, a full-width laminate should be used.
When using smart card or registered laminates and the length is too long or too short, use the
Length Adjust (mils) option to make length adjustments as required.