User's Manual

72 Zebra P630i & P640i Card Printer User’s Manual 980541-003 Rev. B
Settings and Adjustments
Adjustments
Laminator Station Adjustments
To access the Laminate Station Adjustment screen, select Start > Printers and Faxes. Right
click on the Zebra P630i or Zebra P640i printer listing. Select Properties > Device Settings >
Printer Adjustment > Laminate Station Adjust...
• Length Adjust (mils) - This is the length of the laminate patch. If the patch is too long,
decrease this number, and vice versa.
• Horizontal Offset (mils) - Adjusts laminate placement on the card.
• Heater Temperature - This is the set point temperature (i.e., the temperature desired) not
the actual temperature. For actuals, see Access Printer Sensor Data on page 49.
• Line Voltage - If Auto is selected, the printer guesses line voltage based on line frequency,
assuming that 110V will be @ 60Hz and 230V @ 50Hz. If this is not the case in your
locality, the printer will guess wrong; and you should set the voltage manually.
Note • Temperatures are monitored by thermocouples at the core of the heated rollers.
Surface temperatures may differ significantly.
Caution • Running the printer at 220V, 60Hz in Auto mode may cause premature failure
of the heaters. Running the printer at 110V, 50Hz in Auto mode may cause abnormally
long heat-up time and poor temperature control. Either will result in a heater error
message in the printer status screen.