User's Manual

Settings and Adjustments
Adjustments
980541-003 Rev. B Zebra P630i & P640i Card Printer User’s Manual 71
Flip Station Routines
To access the Advanced Utilities screen, select Start > Printers (or Printers and Faxes). Right
click on the Zebra P640i or Zebra P640i printer listing. Select Properties > Device Settings >
Control > Advanced Utilities.
• Tests: Activate various flip tests, used to troubleshoot flip station problems; and activate a
card eject cycle.
• Flip Test 1 - Picks up a card, runs it to the flip station, flips it, raises it to the laminator
infeed, then ejects it through the laminator. The sequence repeats until the
PRINT
button is pressed and released.
• Flip Test 2 - Picks up a card, runs it to the flip station, flips it, returns it to the Platen,
then backs it out to the card sensor (by the mag head). The sequence repeats until the
PRINT button is pressed and released.
• Flip/Pause - Picks up a card, runs it to the flip station, raises it to the laminator infeed,
then holds this position (termed the Insertion Height in the flip station dialog) until the
user presses the PRINT button (at which point the flip carrier descends, and the truck
returns the card to the hopper).
• Eject Card - Picks up a card, runs it to the flip station, raises it to the laminator
infeed, then ejects it through the laminator. Like Flip Test 1, but done once only, and
without flipping.
• Move Carriage: Use this button to move the card carrier to the desired position. This is
useful when adjusting the mechanical settings on the printer.