User's Manual

6Zebra P630i & P640i Card Printer User’s Manual 980541-003 Rev. B
Introduction
Controls and Indicators
RIBBON Button
This button is used to synchronize the ribbon – in other words, to position it correctly under
the print head. If you hold the
RIBBON button down and power up the printer, it toggles on/off
the Ribbon Synchronization feature when the door is closed.
In standard applications, the ribbon type is
YMCK, and the back of the card is printed first. In
such cases, pressing the
RIBBON button will advance the color ribbon to bring the leading
edge of the next black panel under the print head.
If back side printing is not enabled, the printer will synchronize on the next yellow panel when
the
RIBBON button is pressed.
LAMINATE Button
(For the P640i Printer, this applies to the Upper and Lower Laminator; the P630i Printer has
only the Upper Laminator.)
If either (or both) of the laminate transfer rollers is not loaded with a laminate patch, then
pressing the
LAMINATE button will correct the condition, provided the cassette is not out of
laminate, and if the cassette latch is closed (locked).
If both transfer rollers are already loaded, the
LAMINATE button has no effect.
If you hold the
LAMINATE button down and power up the printer, it toggles on/off the
Ribbon Synchronization feature when the printer is powered up.
A standard use of the
LAMINATE button is in reloading a transfer roller after removing the
first hand-cut patch of laminate following installation of a fresh roll.