User's Manual

©2016 ZIH Corp. All rights reserved. Zebra and the stylized Zebra head are trademarks of ZIH Corp., registered in many jurisdictions worldwide. All other
trademarks are the property of their respective owners.
7 Regulatory Requirements
Add a Labeling Section and a Documentation Section
7.1 Host Labeling:
The FCC and Industry Canada require that the FCC ID and the Canadian Listing ID be visible on the end
unit. If the label on the module is not visible when the radio module is installed, the contents of the
label must be placed on a permanently attached label on the outside of the device.
See example of required labeling for a Host device that contains the radio module,
7.2 Module Documentation:
The following statements must be included in the Host Documentation
To comply with FCC RF exposure requirements, antennas that are mounted externally at remote
locations or operating near users at stand-alone desktop of or similar configurations must operate with
a minimum separation distance of 34 cm from all persons.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received including interference that may cause undesired operation.
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Cet appareil est conforme exempts de licence le flux RSS de Industrie Canada. Son fonctionnement est
soumis aux deux conditions suivantes:
(1) Ce dispositif ne peut causer des interférences; et (2) Cet appareil doit accepter toute interférence, y
compris les interférences qui peuvent causer un mauvais fonctionnement de l'appareil.