User's Guide

2 - 4 Workabout Pro4 (Windows Embedded Hand-Held 6.5) User Manual
Charging the Battery
Batteries shipped from the factory are charged to approximately 40% of capacity. Lithium-ion battery packs
must be fully charged before use. These batteries can be charged with a variety of chargers and docking
stations. For detailed information about these accessories, please see Chapter 5: “Peripheral Devices &
Accessories”.
Normally it takes 3 to 4 hours to charge a battery.
The Keyboard
This hand-held is equipped with a [Power] button in the lower left corner of the keyboard.
The [FN/BLUE] modifier key provides access to additional keys and system functions. These functions are
colour coded in blue print above the keyboard keys.
IMPORTANT If your Workabout Pro4 fails to power up, consider the following
troubleshooting options:
The battery may be overheated (>60C°), a non-Motorola battery
may be installed, or the battery may have fallen below the config-
ured Suspend Threshold. See “Suspend Threshold and Estimated
Battery Backup” on page 4-10 for details.
To switch on the hand-held, you will need to replace the overheated
battery.
However, if you supply AC power to the Workabout Pro4 with a
battery that falls below the configured Suspend Threshold, the
unit will
switch on.
IMPORTANT RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO INSTRUCTIONS.
% Charge Completed During Sleep Mode While Operating
100% 4 hrs. 8 hrs.
75% 2 hrs. 6 hrs.
IMPORTANT To avoid damaging the battery, chargers will not begin the charge
process until the battery temperature is between 0°C to 45°C (32°F
to 113°F).
Workabout Pro4 Variant Keyboard Type Available
Workabout Pro4 Long Alphanumeric only
NOTE Almost all keys can be reprogrammed to suit your requirements.
Draft #5