User's Guide

5 - 6 Workabout Pro4 (Windows Embedded Hand-Held 6.5) User Manual
Charging a Battery Installed in the Workabout Pro4
• Insert the DC power cable to the DC IN socket on the desktop docking
station. Plug the pronged end of the cable into an AC outlet.
• Slide the hand-held into the docking station, making certain that the LIF (Low Insertion Force) port on base
of the Workabout Pro4 is securely seated on the docking station connector pins. An icon is displayed
briefly in the navigation bar at the top of the hand-held screen indicating that the unit is properly installed in
the station –
.
The LED on the Workabout Pro4 lights up indicating that the unit has external power and battery charging
will begin. It is safe to leave the unit in the desktop docking station while it is not in use – the battery will not
be overcharged.
Charging a Spare Battery
• Insert the battery in the spare battery charge well at the back of the docking station, aligning the contacts
on the battery with the contacts in the spare battery charge well.
Battery Charge Duration
A fully discharged battery can take up to 5 hours to charge. The desktop docking station stops applying power
to the battery when it is fully charged – there is no risk of overcharge if the battery remains in the charge well.
Charger LED Indicators
The desktop docking station is equipped with a single dual-coloured LED indicator in the lower-right corner of
the front panel.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS.
LED Behaviour Charge Status
Off No battery detected in the slot.
Solid Green Charge complete.
Fast Flashing Green Battery charged to less than 80% of capacity.
Slow Flashing Green Battery charged to greater than 80% of capacity.
Solid Red Battery temperature outside of charge range –
0° C to 50 °C.
Flashing Red Battery is not charging. Battery fault.
NOTE Battery charging continues whether the hand-held is switched on or off.
Draft #5