User Guide

Using the ZebraStat
4
To use your ZebraStat, follow these steps:
1) Decide the mode that you want to use
2) Hook up appropriate leads to equipment
3) Manipulate Mode & Component switches
4) Observe the LED’s and equipment tested
Explanation of steps:
1) Mode.
ZebraStat operates in 3 different
modes. You can easily leave it hooked up and
use all 3 modes on the same equipment as
needed. The 3 modes are:
• Continuity - This mode tests that the wires
that you connect to electrically ‘go some-
where’. For instance, the wire that you con-
nect to the FAN lead normally goes through a
fan relay, and the continuity mode will tell you
if there is a continuous circuit through that re-
lay on the other end of the equipment’s wire.
• Analyze - This mode simply displays the
power flowing through the circuits that your
leads are connected to. First, the red LED’s
tell you power is available in the equipment.
Yellow LED’s light when the thermostat is call-
ing for heating, cooling, fan, or reversing valve.