User Guide

Continuity Mode
12
Continuity Mode tests that the wires your
ZebraStat’s leads are connected to ‘go some-
where’ electrically. For instance, the wire that
you connected the FAN lead to normally goes
through a fan relay. Using this mode will tell
you if there is a continuous circuit through that
relay on the other end of the wire.
1) Turn all thermostat functions to OFF.
2) Turn all the
ZebraStat’s component
switches to OFF, and put the Mode Switch in
the ANALYZE position.
3) Attach the
ZebraStat’s component leads to
the appropriate equipment wires, then attach
the Red and Blue power leads to the
equipment’s 24VAC hot and common wires,
observing polarity.
4)
Verify that no yellow LED’s are lit before
proceeding. If they are, recheck thermostat
for ON (or wiring for shorts) before continuing.