Specifications

33
red and Green safeguard circuit. Disconnect
the scanner from its power source
immediately and contact your
dealer.
The scanner does
not accept more
than two or three
barcode labels.
z There is no proper handshaking
with the POS system. Switch on
the POS system and check
connection and communication
settings.
z The scanner is continuously
seeing a barcode. Remove all
barcode labels out of the scan
volume of the scanner and try
again.
z The scanner cannot send the
data to the POS system. There
is no proper handshaking
between the scanner and the
host. Make sure that all cables
are connected and your POS
system is ready to receive data.
A barcode is read by
the scanner but not
accepted by the
POS system.
 The communication cable is not
connected to the serial port of your
POS system. Refer to the
manual of your POS system to
locate the serial port.
 The communication settings of the
system and scanner do not match.
Adjust the settings in order to be
equal for both devices.
 The communication cable does