User's Manual

USER’S MANUAL
Handy Wireless Scanner
20
Start Of Configuration
SPP Master Mode
In this mode, the scanner connects to the host /PC via wireless connection and performs
like there’s a serial connection. In master mode,
the scanner initiates the connection to
the remote device.
1. Power on of the remote device and have its address ready in hand and make
it discoverable.
2. Program the scanner with the “SPP Master enable” barcode.
Scanner SPP Master enable
Enable SPP Master mode.
3. Scan “Set device address” to set the address.
Set device address
(SPP Master only)
Set device address for SPP Master
connection.
4. Use the ASCII table in Programming Guide to input the 12 digit device address.
For example: if the address is “011B1345600”, scan “0”, “0”, “1”, “1”, “B”, “1”,
“3”, “4”, “5”, “6”, “0”, “0” from ASCII barcode labels.
5. Scan “Confirm Setting” to store the address.
Confirm Setting (for address and pin code
setting required)
6. Setup and input the pin code if necessary. Please see Setting Pin Code section
for more details.
7. Scan “Required Pair with slave (SPP Master)” to begin pairing.
Required Pair with slave (SPP Master)
In SPP Master mode, you can scan the device address label on the
Quick Guide instead of using the ASCII table to scan in the address.
End Of Configuration