User's Manual
Table Of Contents
- Important Notice
- Introduction
- Programming Guide
- Connecting to a Host
- System Function Settings
- Scan Mode
- Radio Communication Setting
- Operation Function Setting
- Interface Settings
- The Symbologies
- Codabar Parameter Setting
- Code 39 Parameter Setting
- Code 93 Parameter Setting
- Code 128 Parameter Setting
- Chinese Post Code Parameter Setting
- MSI/Plessy Parameter Setting
- Code 11 Interface Setting
- ITF 2 of 5 Parameter Setting
- Standard 2 of 5 Parameter Setting
- Industrial 2 of 5 Parameter Setting
- UPC/EAN/JAN Parameter Setting
- Telepen Parameter Setting
- Matrix 2 of 5 Parameter Setting
- Data Editing
- Appendix 1: USB Virtual COM Driver Installation
- Appendix 2: Barcode Length Setting
Handy Wireless Scanner
9
USER’S MANUAL
Dongle LED
Please see the following for the operational indication of the scanner.
LED Status Indication
Blue flashing Dongle is detected by the host,
communication not yet established
Steady blue Dongle is connected to the host
Blue flash once Data transmission
Steady red Dongle is plugged into the host but not
detected by the host or dongle is in the
update mode
Sound Indicators
When the scanner is in operation, it provides audible feedback. The beeps indicate the
status of the scanner.
Beep Indication
A long beep Power on scanner.
One beep A barcode has been successfully decoded and data is
either transfer to the host or saved in the memory.
1 high - low - high beeps Scan dongle pair barcode.
Four short medium beeps Data communication failed or out of range.
Intermission medium-low
beeps
Low battery warning.
1 short medium – low beeps Scanner is power down.
1 long high – medium beeps Enter programming mode.
1 long medium - medium
beeps
Exit Programming mode.