User's Manual
Table Of Contents
- Important Notice
- Introduction
- Programming Guide
- Connecting to a Host
- System Function Settings
- Scan Mode
- Radio Communication Setting
- Operation Function Setting
- Interface Settings
- The Symbologies
- Codabar Parameter Setting
- Code 39 Parameter Setting
- Code 93 Parameter Setting
- Code 128 Parameter Setting
- Chinese Post Code Parameter Setting
- MSI/Plessy Parameter Setting
- Code 11 Interface Setting
- ITF 2 of 5 Parameter Setting
- Standard 2 of 5 Parameter Setting
- Industrial 2 of 5 Parameter Setting
- UPC/EAN/JAN Parameter Setting
- Telepen Parameter Setting
- Matrix 2 of 5 Parameter Setting
- Data Editing
- Appendix 1: USB Virtual COM Driver Installation
- Appendix 2: Barcode Length Setting
USER’S MANUAL
Handy Wireless Scanner
7
Radio Communication Host Type
This scanner support three radio communication types:
Dongle mode
SPP master/slave mode
HID mode
Dongle Host Mode
The scanner communicates with the host through the dongle. One dongle can be used to
connect multiple scanners.
Typically, scanner and dongle in the same delivery box are paired in factory. As soon as
both are powered on, they should find and connect to each other immediately.
However, under special circumstance that the scanner and the dongle are not paired with
the dongle, please follow instructions in later chapters to pair the dongle.
SPP Master/SPP Slave Mode
The scanner can communicate with the host through wireless connection.
Please see Wireless Mode for detail operation information.
HID Mode
The scanner communicates with the smart phone through HID connection.
Please see HID mode for detail operation information