User's Manual
Table Of Contents
- Important Notice
- Introduction
- Programming Guide
- Connecting to a Host
- System Function Settings
- Scan Mode
- Radio Communication Setting
- Operation Function Setting
- Interface Settings
- The Symbologies
- Codabar Parameter Setting
- Code 39 Parameter Setting
- Code 93 Parameter Setting
- Code 128 Parameter Setting
- Chinese Post Code Parameter Setting
- MSI/Plessy Parameter Setting
- Code 11 Interface Setting
- ITF 2 of 5 Parameter Setting
- Standard 2 of 5 Parameter Setting
- Industrial 2 of 5 Parameter Setting
- UPC/EAN/JAN Parameter Setting
- Telepen Parameter Setting
- Matrix 2 of 5 Parameter Setting
- Data Editing
- Appendix 1: USB Virtual COM Driver Installation
- Appendix 2: Barcode Length Setting
USER’S MANUAL
Handy Wireless Scanner
4
Charging the Battery
To charge the battery using the USB cable:
There are two method to charge scanner via USB cable.
Host USB Power
Power adaptor
1. Connect the micro USB connector directly to the scanner.
2. Connect the other end of the USB connector to the host to begin charging.
You can also connect the USB cable to an outlet using the power adapter to
charge the battery.
3. The battery begins charging when the scanner LED indicator starts flashing
green.
LED turns steady green when charging is complete.
The scanner will power on automatically when charging.
Batteries shipped may not be full charged and should be fully
charged for maximum charge capacity.
Recommended charging environment is temperature in 0°C~35°C (32°
F~95°F).