User's Manual

11. Programming Guide
Scanning a series of programming bar code labels can configure the scanner.
This allows decoding options and interface protocols to be tailored to a specific
application. The configuration is stored in non-volatile memory and will not be lost
by removing power from the scanner.
The scanner must be properly powered before programming. If you are about to
change the cradle host of parameter, the scanner and cradle must be in pairing
status to prevent failure in programming operation.
During the programming mode, the scanner will acknowledge a good and valid
reading with a short beep. It will give long beeps for either an invalid or bad
reading.
11.1 Default Parameters
The factory default setting table gives the default settings of all the programmable
parameters. The default settings will be restored whenever the "Reset"
programming label is scanned and the laser scanner is in programming mode.
Factory Default Setting
Parameter Default
Radio communication
Bluetooth Host Cradle Host
Pairing mode Unlocked
Data transmit Normal
Radio protocol timeout 5 seconds
Power off timeout 20 minutes
Encryption Enable
Cradle Host
RS-232 communication
Baud rate 9600
Parity none
Data Bits 8
Stop Bit 1
RTS/CTS off
Terminator <CR><LF>
Keyboard Wedge Communication
Terminal Type PC/AT
Keyboard US keyboard
Terminator Enter(Alpha numeric)
USB Communication
Terminator type Enter
Code mode Scan code
32