User's Manual

6. Select “ZBBT” the scanner, as the scanner default encryption is

enabled, and you will be requested to enter the PIN code as

“12345678” to start pairing.

Figure

7. Double click on “ZBBT” selection and find as follow,

Figure

8. Right click on the icon and select “Connect Bluetooth Serial Port”.

Once pairing is completed, the scanner will make low-high beep tone

and the LED light in GREEN.

Note:

When scanner is set in slave mode, and the master device supports

Piconet, this master device can connect with up to 7 slave mode scanners

or equipments at the same time.