Owner`s manual

7
Function of the Zeagle System
The Winglet Side Release Buckles
must be attached to the vest.
Surface Buoyancy
Label Location
Do NOT dive with the two winglet side release buckles detached!
Bladder Assembly
The bladder assembly attaches to the vest section via four stainless steel
slotted fasteners sewn to the inner edge of the bladder assembly. Each of
these slotted fasteners slides over the two Single-Tank Bands. This fastens
the Bladder to the Tank Bands. If the BC is to be used with double tanks,
then the Single Tank Bands are removed and the optional Double Tank
Straps (p/n 7019T) slide through the webbing slots at the back of the vest
just as the removed Single Tank Bands did (see cylinder band illustration
on pages 10 thru 13). The stamped metal ends of the straps are threaded
through the eye of the metal tabs on the Bladder Cover (see illustration
below). There are two plastic buckles on the Bladder Cover Winglets, which
clip over the weight pockets to hold the buoyancy forward. Do not dive with
the two forward small side release buckles detached! The shoulder straps
should pass through the collar at the top of the bladder assembly.
Shoulder strap goes
through the collar
The Tank Bands and the optional double
tank straps go through the same back-
plate webbing slots.
Optional double-tank Straps are
required IF Double Tanks are
mounted to the BC.
p/n 7281M (2 required)