Owner`s manual

Pre-dive Assembly and Inspection

Weight System Inspection

Check to see that weight release system is secure.

Ripcord ™ release system - check bottom of weight pockets to be sure they

are held closed by the ripcord. If the Ripcord

has been pulled, re-thread the

system. (Refer to the re-threading section on following page).

Bx Power Inator/ Oral Inator Mechanism

Your BC will also be equipped with a power inator/oral inator

mechanism. This unit consists of a Bx Coupler, Oral Valve Mouthpiece, Oral

Valve Button, and Pneumatic Ination Valve (PIV) and connects directly to

the RE Valve via a steel cable (inside the corrugated hose). The PIV

operates over a pressure range of 6.5-13.8 bar (95-200 psi). To inate the

BC using the PIV, attach a low pressure hose to the quick disconnect (QD)

tting and depress the PIV button. To inate the BC using the oral inator,

depress the Oral Valve Dump Button and breathe into the Oral Valve

Mouthpiece.

CHECK ALL MECHANISMS BEFORE EVERY DIVE FOR

PROPER OPERATION AND LEAKS.

Before diving, make sure that the Bx Coupler is hand tightened onto

the Power Inator to avoid water getting into the BC.