Owner`s manual

11
There are only minor differences on a twin cylinder model. The rubber
“non-slip” plate should be completely installed on the bottom band opposite
the touch fastener (Velcro) material on the band, before inserting the band
under the webbing on the pack. The bands go under the vertical webbing on
the back plate. If your system has only two pieces of vertical webbing, it is
not a twin cylinder model and should not be used with twin cylinders. If you
are setting up a double pack for single cylinders, please note that the single
size cylinder bands only go under the center 4 inches (10.2 cm) of vertical
webbing on the back plate and the non-slip plate is installed as illustrated on
pages 10 and 12.
Threading the Standard & Quick Release
System on a Twin Cylinder Back Plate
Fitting and Assembly
Standard System
Optional Quick Release System
An alternate method of attaching twin cylinders with steel bands is by bolting •
through the back plate grommets.
Optional band extension used only with quick release band for twin cylinder use.•
Extension strap should be adjusted at cylinder buckle hook end for proper cylinder •
size.
Back Plate Grommets
Optional Band Extension