Owner`s manual
10
Illustration “A”
Non-Slip Plate
(Standard System Only)
(Single Cylinder Band Assembly)
Fitting and Assembly
Illustration “B”
Threading The Standard Single Cylinder System
Note: Tank bands expand and lengthen when wet. For this reason, you will get a tighter t if you
make your initial adjustments with tank bands that have been wet for at least 20 minutes.
Thread the lower cylinder band through the non-slip plate and then under the bottom center 1.
backplate straps as shown in Illustration “A.”
Thread the upper cylinder band under the top center backplate straps on the BC as shown 2.
in "A".
After threading the bands through the BC, thread the bands through the buckle as per 3.
illustration “B”.
Threading instructions are also embossed on the side of the plastic buckle.4.
After Looping the webbing through nal slot in the buckle, check to be sure that your 5.
cylinder is lined vertically on the BC. “Cam” the buckle over for extra tension.
Lock the buckle by engaging the Velcro material on the tank band. 6.