Quick Setup Guide

3. Attach two 1.5M N-type cables to the
reserved antenna jacks, and connect to
the directional antenna.
2. Attach the pole lock frame and screw two
bolts back. Tighten them approximately.
3. Attach two 1.5M N-type cables to the
reserved antenna jacks, and connect to the
directional antenna.
External 5GHz directional-antennas
(Optional accessory_ANT-D5G-23)
Note: Dual linear, ±45°, HPBW/Horizontal 10°,
HBPW/Vertical 10°, IP57 Waterproof
Note: Before screw the directional-antenna, please
reserve 15 cm between the device and antenna.
Note: To prevent radio inflection, it is recommended to
power the device on after rotate the directional-antenna.
1. Align the antenna mount with antenna;
screw tightly all four screws.
2. Unscrew the screws on the two U-bolts,
then attach the pole and align two U-bolts
with plates. Screw the screws tightly.
1. Make your device GND port connect to
ground wire.
2. The ground wire connects to the earth. In
addition, the grounding wire meets to 6-AWG
copper grounding wire.
Grounding & Lightning
Note: Be sure that grounding is available and that
it must comply with local and national electrical
codes. For additional lightning protection, use
lightning rods and lightning arrestors.