Quick Setup Guide

3. Slide the gasket and rubber stopper into
the locking nut.
4. Connect the RJ-45 connector into the LAN
port of the Access Point.
5. Flush the gasket, rubber stopper and
locking nut together into the LAN port
opening, then twist the locking nut to seal
the opening.
6. Slide the sealing cap over the bare end of
the Ethernet cable.
7. Tighten the sealing cap.
STEP 7: POWER AND CONNECT
1. Insert the other end to the LAN/PoE port
on the Access Point.
2. Insert the other end of an Ethernet cable
to the P+D/OUT port on the PoE injector.
Make sure the Cat5e cable from the
Access Point is long enough to reach the
PoE injector.
3. Insert one end of an Ethernet cable to
the DATA/IN port on the PoE injector as
figured above.
4. Connect the other end of the Ethernet
cable to the switch or a PC.
5. Connect a power cord to the PoE injector.
6. Connect the power plug to a wall socket.
6. Perform a spot-check to verify if the
PWR and LAN LED are lit to make sure the
AP is operating normally
STEP 8: VERIFY THE CONNECTION
1. Use any wireless-enabled computer or
mobile device to search for and select the
wireless network you’ve previously
configured.
2. If you can connect, open a browser and
link to any public Web site.
Caution:
1. Make sure that you form a 3”-5” drip loop in
any cable that is attached to the Access
Point. This will prevent water from running
along the cable and entering the Access
Point or the building where the cable
terminates.
2. Be sure that grounding is available and that
it meets local and national electrical codes.
For additional lightning protection, use
lightning rods and lightning arrestors.
3. From PC’s Network - Wireless Properties
page. Observe the wireless signal quality
and speed.
External 5GHz directional-antennas
(Optional accessory_ANT-D5G-15)
Note: Linear, ±45°, Horizontal Beam width 3dB: 60°, 6dB:
90°, IP55 Waterproof
Note: In order to prevent the radio inflection, it’s
recommended to power the device after rotate antenna.
Note: Before screw the directional-antenna, please
reserve 15 cm between the device and antenna.
Note: The pole lock frame can accommodate 3.81~7.62
cm (1.5’’~3’’) in diameter.
1. Attach the antenna above the device and
unscrew two bolts and take pole lock
frame off on the directional-antenna.