Quick Setup Guide

10. In Network Authentication, select the
desire authentication method and then
enter the encryption phrase accordingly.
11. Click Apply to save the changes.
12. Click Logout to exit the Web interface.
STEP 4: VERIFY THE CONNECTION
1. Connect the AP to your network.
2. Use any wireless-enabled computer or
mobile device to search for and select the
wireless network you’ve previously
configured.
3. If you can connect, open a browser and
link to any public website.
STEP 5: INSTALL THE AP
1. Disconnect the AP’s power adapter from the
power outlet (or disconnect the PoE cable).
2. Move the AP to its permanent location
(accessible to both power source and
network connections).
Note:
Some placement guidelines you should follow to
maximize performance and coverage.
The Access Point ‘s ideal orientation is pole
mount (e.g street light pole) with its dome
pointing straight down. All APs should be
mounted as high and as visible as possible. 10
meter installation height least is suggested. Try
to avoid any obstructions, especially those in
close proximity to the AP . The signal strength it
will receive depends largely on its position, so
make sure that sufficient survey has been made
to determine the best placement for maximum
range, coverage, and network performance
before installing. Nevertheless, as RF can be
affected by many variables, your actual
performance may vary from the planned design.
5. Secure the Access Point and mounting
base to the mounting bracket with the
spring washers and screws.
6. Align the Access Point and mounting
base assembly with the mounting
bracket.
7. Insert the adjusting screws through the
mounting base and secure.
Note:
Do not tighten the screws completely at this
time to allow for final tilt down adjustments.
MOUNTING THE ACCESS POINT
1. Secure the Access Point to the mounting
base with the provided screws.
2. Press the mounting bracket to the T-bar at
a pre-determined location.
3. On the opposite side of the T-bar, position
the T-bar clip.
4. Insert the washers over the retaining
screws and insert through the T-bar clip
and into the mounting bracket.
STEP 6: WATERPROFFING THE CABLE
You need to waterproof the LAN port using the
supplied sealing cap.
1. Slide the locking nut over the bare end of
the Ethernet cable.
2. Slightly pry open the gasket and rubber
stopper, and insert the Ethernet cable.